Leaderboard

Thread revival from the DEAD! I finally got my Krypt board rack put up after about 4 years. Bought them on clearance years back and I've always had DIY pvc racks for years. Wanted something a little more streamlined for the new shop (which isn't new now after 4 years ) Anyway here it is!!

Finally did mine but went with the Angled Starboard and Port side specific LED's.

I would rip the tanks out and fill the areas with sacs and possible some well placed lead bags. You will get a lot more weight than the tanks, and then you also get more storage for times the ballast is not full. Note that you will want the rub rail on the surf side at the water line when surfing. The tanks will not accomplish that.

Thanks for the welcome! It has 4 factory ballast tanks and a switchblade system on the back and perfect pass. Anxious to see how well it will work. It also came will 2 individual fat sacks that they placed in the 2 rear wells to add additional weight. Hopefully I am set for weight. I am about 190 but my boys are 7 and 9, they are light enough to enjoy the wave I'm sure. I am new to owning a surf boat, so we will see how it goes. Thanks again.

Haven't been on here in awhile and/or updated my Thread. Seems like I'm always doing something to the boat and run out of time to post Anyway I just finished up installing some RubRail Docking lights and VisionX rear facing tower lights. For the tower lights I used the existing lower speaker locations and tower wiring and grabbed a set of adapters. The hardest part of the install was cutting out the rocker switches. The rubrail docking lights were a bit harder since I had to build up the nerve to take a cutting wheel to my boat and measure a million times to ensure I was able to re-use the existing rub rail screws to install the coverplate over the light housing. It actually wasn't too bad. I located the rocker switches in the right armrest cover plate at the top and bottom edges. It looks like it came like that from the factory which is the look I was going for. Now it's time to go use her for the season again ......whoot whoot!!!

This is a better pic, its from last Spring right after installing the Infinity Wave surf tabs and before adding the bolt-on "spray plate" from Fresh Air Exhaust

No, the little plate you see on the FAE is the bolt-on kit that Fresh Air sent me after the fact to help with the spray.