truekaotik

Ok for those of you who's vdrives are leaking but you want to make sure FIRST it needs removed. Here is some info I got from the vdrive manufacturer... He stated that a vdrive shouldn't leak from any orifice by design and if it does, follow these steps to find the culprit... It should only need pulled to replace the main seal to the shaft if damaged and leaking a drip ever second.. All this is hand tighten specs.. 1. Wipe the vdrive and floor under completely free of oil. 2. Make sure all oil plugs and hoses are tight. 3. Make sure the 4 9/16 pan bolts are tight. Easiest to use a wench for most of this. 4. Make sure all coupler bolts are tight. 5. make sure all top pan bolts are tight. 6. Make sure the 4 bolts of the shaft plate are tight... 7. Check oil level and correct then re-wipe down the vdrive. 8. (Optional) place a white piece of paper under drive and let sit for a day or so to see if you found the culprit.. He said you should check them at the beginning of EVERY season.. This fixed my severe leak issue, I passed it onto a couple other crew members and it worked for them. Saving the hassle of pulling the vdrive or the expense... I hope this helps some with minor/major oil leaks that were noticed in the bilge stemming from the vdrive...

Does anyone have a valid surfinity blanket discount code?

Does anyone have a valid surfinity blanket discount code?

Does anyone have a valid surfinity blanket discount code?

Good job brother!!!

You need to cross vent and drain to opposite sides and you won’t have issues with those. If the fill pump has a good impeller it should be fine.

What head unit did they replace it with? Question is do you want to go through changing a head unit or remotes? If the remotes work, that is?

A inboat speaker sits in direct UV light constantly and they get wet from time to time. I would not use a ARC car audio speaker for this application.

Remove the wall or facade and you have a ton of space for the new enclosure. You can re-use the factory facade if you want or make a new one.

You can go all wet sounds from go or, install everything you have and tune it with the Rossell’s. If your not happy, it’s a easy swap out on the Centurions.

Rhunt we have been using them since Beta version on the sand bar. It can get loud?

We talked about this, YOU need to decide what YOU want.... hehe

That is friggin SICK looking Ken!!!

Basic... hehe

You will have two wires coming from the Perko, correct. One to each battery. Main negative to one then jumped from negative to negative of other battery. All other ground can go to whichever battery is closest to them wiring slack wise. Just make sure all ground are connect and one or a couple didn’t fall somewhere weird. you can do EBay for the center cushion or make one, several have done it here for a very long time.

I would look upstream at amplifier, on the signal side for that channel that powers those speakers. If it’s singled out to only those speakers ( rear cockpit two) then it’s in amplifier or upstream most likely, as factory has them on one channel.

We leave In if your inside and it's away from animals and the weather.

Sooooooo.... I switched brands and just wanted to let everyone know. Dealer support is huge on a expensive boat like these and our Centurion dealer is lacking... So here it is... Supra SE....

It has a the 450 Raptor motor in this one Chad. i won't be a stranger DrNate!

In those years only the tower changed and some cosmetics..

In those years only the tower changed and some cosmetics..

Prolly the ZLD crapping out, bypass it, that will tell you.

Nice... That wave could be so much longer though, what's your weight and speed? I see a suck gate is being used.

Thanks guys! Kai it has 4 8.8 JL towers, 6 JL interiors and I switched out the JL 10" sealed sub with a Wet Sounds Xs12 in a slot port. Two 800.8 JL amps and added a Syn2. Dark, I will post them here as well but the wave videos are on Facebook. Hehe I think you seen them after your post though I think I got it pretty big, long and powerful after some lead and tweaks.