bobhauck

the guy who owns the boat is on here. He posted a while back about the boat. I thought he might have said he had the cushions.

Thanks. I did take it out on Saturday. It was still cutting out. Its not so bad you can't drive the boat, you just have to be aware of it. I am going to replace the IAC and the throttle position sensor next. I know its probably not the TPS but I'll have it off and the boat is 12 years old so why not?

Thanks. I did that and am charging both batteries. I also inspected and adjusted the throttle linkage. I'm going to take it out Saturday, if it is still doing it I will check the IAC valve.

Anyone know where I can get a 2" fin for a phase 5 board with a screw through in the Sacramento area by this weekend? Thanks in advance.

I am pretty sure they did the cap and rotor but I will check that also. Thanks

This is the only one I have.

I also use the Babes products and have been very happy with them.

Yes the dealer did the routine service in April. Impeller, fuel water separator, oil change, etc. It was running perfect the first day and a half then started doing it the last part of the 4 day lake trip.

I have a 2005 Avalanche with the black scorpion motor. If I shift from reverse or forward to neutral too quickly the engine dies. I was thinking it might be the interrupter switch but I was not sure how to adjust it. Any insight would be great thanks.

I just picked one up for my boat that I found on Craigslist. Got really lucky. I'm sure you could call fine line for one but I can't even imagine what they would cost.

I agree. I just happened across it on Craigslist when I was kind of thinking of switching and decided to go for it. On a side note. Does anyone know where I could get the rubber and stainless steel rub rail for the swim platform? Thanks

It is a factory swim platform. I found it on Craigslist for $250. Brand new never been used. I just have to figure out how to mount it now.

I've seen that posting. Any ideas on how many hours it has? Is the guy willing to drive anywhere for a test drive. I might be able to meet him at Modesto reservoir for ya. There is another clean one for $24k in the Fresno area.

I found a really good deal on a brand new fiberglass swim platform. I would like to switch out my teak one on my Avalanche. The current teak one is warped and separating. What size are the stock ones? Any drawbacks to the fiberglass one? Thanks in advance.

https://sfbay.craigslist.org/pen/boa/6068029436.html