Dieselbreath

Did you install the cross bar and pin it on the sides as asked in the post above. Mine is a 17 and is straight tight and plenty tall.

Thank you Honcho for your info!

Was able to get a hold of gator step and their recommendation for blood was a mixture of bleach and water. 1gallon water to a cup of bleach, I cut that recipe in half not needing a large amount. Low and behold it appears that it may be gone, we will see when the flooring dries completely. If so I will be so much happier, all of the stains were very obvious and in the biggest most visible panels. Now for the threat of rain to stop so I can uncover the boat, vacuum it out and clean/treat the interior. Boat juice is calling my name.

I also would love a copy if it is for the 409 in a '17.

This is what the flooring looks like, this is on the trailer since the boat is all covered up.

So last weekend out on the lake my daughter ended up with a cut on her toe. In the process we got a couple spots of blood on the flooring of the boat. (not Carpet or fiberglass) I believe it is the Gator step flooring and clues as to how to get it out without damaging the floor?

What collonite is everyone using?

Start with battery voltage is________? Then move as others have stated to the same voltage can be tracked at the starter big terminal? When you try to start the boat does the small terminal from the key show 12 volts at the starter? Do you have the same voltage at the ACC terminal on the ignition switch? Verify continuity thru the kill switch and the breaker near the engine? Report back when you can answer these questions with voltages not just telling us the test light lights up.

I was think the over the tower for winter and the factory for summer and back and forth to the launch.

I have what looks like the same brackets on my '17 S238. I can lower my tower but have to put the throttle in the reverse position to do so. You also must hold in on the arm slightly or it will catch the upholstery.

This would be a very viable option also. Could be placed on a timer so it could cycle on and off. https://www.amazon.com/Kats-13150-Aluminum-Circulating-Heater/dp/B000BQUUR6

Wish i had a brake. I could tig weld that thing up. Would be a nice addition.

Get a good look around left over loaded '17's are out there. I just picked up a loaded 3500 cummins for 60k. 4x4 aisins trans, crew cab.

Traded off the old for the new!

What year 244?