xj1514
Crew-
Content count
216 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Member Map
Store
Calendar
Classifieds
Everything posted by xj1514
-
Mines not fairing well either, screws backing out, molding all wavy, even the metal is bulging out 1/4". Let me know what you find.
-
This is all ballast full, 4 people on surf side.
-
More stinger in my experience runs the wave longer, less is short pocket and very rampy. I use both, very dependent on the board for me of which style wave I ride. Have you tried filling the bow pnp as well?
-
XJ's Official S238 thread...pictures
xj1514 replied to xj1514's topic in Supreme Boats General Discussion
Lets just say the Supremes in my area with spray dates if the same time period are having the same issues. I don't think the boats are bad, just a bad production run, trying to squeeze too many boats out due to high order numbers. This boat will only put out a massive wave sacked out with upgraded ballast and lead, I have about 55 hours on mine now figuring it out. Handling sacked out is piggish, Im not sure if there are any that handle great when loaded, manageable but not great. Free board is mid range in my opinion. Its taller than the Sangers, but looks a little lower than most the new Malibu's I've seen on the water. I let an experienced driver run the boat for a set and we took on a ton of water over the bow...from our own rollers, he forgot to slow down, bump reverse, and head in between the rollers. Hope that helps. -
Strange how all these boats perform differently. Glad you like it.
-
Lets see pictures of the wave from a few angles. Sounds like a small pocket, steep wave?
-
XJ's Official S238 thread...pictures
xj1514 replied to xj1514's topic in Supreme Boats General Discussion
So long as they stand behind the product, that is yet to be seen on my end. Dealer is doing his part, not sure on the manufacturer. -
XJ's Official S238 thread...pictures
xj1514 replied to xj1514's topic in Supreme Boats General Discussion
Yup, the G's are losing props due to shaft failure. Quality. -
Thanks
-
This is what my mechanic said as well. Where are the vents at so I can keep an eye out?
-
[Official] 2017 Supreme Surf Ballast/Tab Setup Thread
xj1514 replied to Cwazy1's topic in Supreme Boats General Discussion
1. Boat Model: 2017 S238 with 1100 lb fly highs in rear locker 2. Regular or Goofy: Both 3. Bow Ballast Percent: 100% 4. Center Bow Tank Ballast Percent: 100% 5. QF Port Percent: 100% 6. QF Starboard Percent: 100% 7. PnP Port Weight: 100% 8. PnP Starboard Weight: 100% 9. Other Ballast Weight (ie. Lead): 600 total, 200lbs in each port and starboard locker far back under cup holder, and 200 in starboard back locker, move remaining 200lbs to surf side on floor 10. Number of Crew and positioning: 4 to 8 adults. Most on surf side, one or two in bow to keep push and lengthen wave 11. QuickSurf Port Setting and 12. QuickSurf Starboard Setting are set at 70 and 0, and conversely 0 and 70 13. Stinger Tab Setting: 0 to 30, depending on water conditions and wind 14: Picture: http://i1239.photobucket.com/albums/ff502/xj1514/958969FC-E05A-4465-A038-DE6C8C2B8944.png -
Might buy a Supreme, looking for advice
xj1514 replied to ksullens's topic in Supreme Boats General Discussion
Not sure if this answers your question, but in 2015 Correct Craft bought Centurion and Supreme. As far as build quality, in general my opinion is it goes Nautique, Centurion, then Supreme...so far as the Correct Craft family boats go. -
Quicksurf stopped working
xj1514 replied to J Hooper's topic in Supreme Boat Maintenance, Performance, Troubleshooting
Is there a resetable switch under the dash or in the storage compartments? Or a regular fuse that is blown? -
2013 V226 Surging
xj1514 replied to lakerat's topic in Supreme Boat Maintenance, Performance, Troubleshooting
Gauge can be had at napa as well as the fittings. I would dump the Heet in there and see if it was water first, then move to fuel pressure. Plugs all look good? Hooked up? Not fouled etc? These are all the things your dealer is going to check... -
Cost effective, and entry level boat should be under 40k...like Bayliner.
-
I'll look mine over a little more, my bilge is dry though.
-
Lol. Funny stuff right there.
-
G23 or Ri237 are top on my list but really want ti stay at the same'ish pricepoint. Either way this boat is getting traded in even if its on an 18' 238
-
What Cleaning products are y'all using?
xj1514 replied to Newman44's topic in Supreme Boat Maintenance, Performance, Troubleshooting
Starbrite marine polish is awesome. Now I need a wax... -
2013 V226 Surging
xj1514 replied to lakerat's topic in Supreme Boat Maintenance, Performance, Troubleshooting
Is there a port where you could thread in around the fuel filter or pump area to get a gauge on it to check pressure? -
The 230 is scheduled for demo in October as they are out of stock at the moment, that is most likely what I will be looking to get. Does it not surf well? Ive read it needs some extra weight as well.
-
Redneck ingenuity at its finest.
-
I demo'ed a stock 17' 226 before I got my 238, and have never seen a dialed in 226, but I can say with extra ballast my wave is impressive in height and shape, but not length. The push goes away as I try to get a longer wave. Also, I took out lead this weekend to try to wakeboard, and the surf wave got tiny and didn't improve the wakeboard wave. This will be my only season in a 238 if I can help it. Very finicky, lots of issues, and doesnt wakeboard at slower speeds.
-
Hey mine too! Really annoying. Have not found a fix yet.
-
Without 1100's and 600 lbs of lead and 4 people minimum in the boat, the surf wave is less than impressive. The lead must be placed far back in the lockers.