Jump to content

pauld

Crew
 View profile  See their activity

  • Content count

    9

  • Joined

  • Last visited

Community Reputation

1 Neutral

About pauld

  • Rank
    Newbie

Profile Information

  • Gender
    Male

Previous Fields

  • Boat
    Centurion Carbon Pro
  1. @cottonwood - what setup tips do you have? We have a new to us 2012 and I would like a little lower spray if possible!!

  2. Carbon Pro prop question

    pauld replied to jimbeam's topic in Centurion Boats General Discussion

    Std tranny (at least on the 343) is 1.26:1 reduction

  3. need a perfect pass

    pauld replied to droopypowers's topic in Centurion Boats General Discussion

    Assuming this is an 08 with DBW - why don't you put a Zero Off unit in it?
  4. Update for anyone who cares or who may go through this in the future. I gave the part number (44-146-20-1) and customer part number (7050-15000-03) to AIRMAR. They said this is a custom made part for Medallion and directed me to speak with them. Medallion's response was that they thought it could be a bad ground so I am currently checking into that...
  5. @poidog1 the VM trailer website actually has a good article in the tech section on the UFP actuator that your trailer likely has. Its pretty easy to pump but you will need two people to do the job - one person to pump and one to close and open the brake bleeder - unless you have a one man kit of course...
  6. Suck out your reservoir and put new fluid in. Then flush the lines with new fluid. I do this every two years to keep my brakes from needing to be fixed. Much cheaper than new master cylinders, etc.
  7. Wow - this is not easy to trouble shoot. I finally got the transducer part number off the cable (44-146-20-1) but now I can't what model the transducer (the tag says Smart IDT-N2000). The head unit is a medallion.
  8. this link is pretty good at describing what you need to do. http://www.vmboattrailers.com/images/UFP_Hydraulic_Brake_Actuators.pdf
  9. Hi, We have recently purchased a 2012 Carbon Pro. The depth finder/temp readout is not working properly. The depth is just dashes (ie doesn't read a number) and the temperature read low (both water and air). Any ideas on where I should start? Thx, Paul
×

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy..

  I accept