So just checked out the boat. There are 2 wires connected to the pos. battery post; One is unlabeled and a size 0 awg (or close) wire and the other is a 6awg wire that is labeled acc 2 batt 2. Both go into the black switch box mounted on the wall. The negative battery post has the following; one size 0awg wire that goes into the bottom of the boat - guessing a ground bar back to the engine, one 6awg wire that appears to head towards the starboard side of boat(guessing breaker panel area), a 4awg wire to ground the amp and 2 smaller ground wires.
I am thinking that if I take both 6awg wires and add those to the 2nd battery that is the way it was from factory? What are your thoughts? Is there a need to then jump the grounds as well?
So I have an understanding of how to operate once this is done, I run the boat all the time in the on position and then if the battery is dead on the water (from radio )I would then switch to combine? The auto bilge bypasses the switch correct and is always powered as long as battery is hooked up?
Thanks for you help! I am looking to swap out the factory MB quart radio this winter and wanted to figure out the battery system first.