wmuller

Any one install an in line muffler? have seen some inserts for speed boats by GGB. any my one try this?

Centurion 2012 sv211, looking to to add rear locker ballast bags. there are unused circuit breakers in my black box How do I use them for my 20 amp jabsco pumps? it is a real rats nest of wires, where is the ground? thanks

Looking at some left over 2015 s226. They do not have quicksurf. How much of a deal to add it? Is this something you trust/ let a dealer add?

What is weight in center ballast? Do u fill it ? Might get 2014 it quick surf is not all that!

Newer models come with quick surf. Why not load boat and just use quick surf? Wife is only goofy and she kinda bows out of riding due to hassles of switching on current enzo211. Friends mastercraft x10 has clean goofy but no push. She really liked clean wake from friends mastercraft. Would have lost her to him it had any push! Lol

Looking at s226 2015 left over Or 2016 for $8k more. Any diffences betwween years?

Any feedback on goofy wake of s226? Have 2012 enzo sv211 and wife surfs goofy. Looking at simplicity of s226 for ballast set up. Wife does not like the computer display as changes overwhelm here.

Hello Cdifranco! Did winnisquam marine help you? Or did you contact fine line directly? Thanks.

Have 2012 enzo sv211. Anyone remove the rear quick fill hard tanks and upgrade to Bags? Thanks

I am the black one. There is a blue black one as a dock mate in jays. Hope to see you out there!

I am in the Winnisquam lake. Thanks for the tips on speed and weight.

Enzo 211. 2012. Trim plate actuator only travels an inch on the arm. Does not seem to affect wake. Can this be adjusted? And where?

My quick fills have already been replaced once. I have a short surf season in New England and last summer ran with out quickfills and used fat sacs in rear locker. My dealer didn't get the replacement quick fills for 2 months. I do not have the surf package on my 211. Have to manually fill bags and wife is annoyed at the process. I was thinking to just bag the rear lockers and avoid the quickfills and their value issues. Wife is goofy and surfs goofy.

I have syn6 amp and two wet sounds tower speakers. Went to move them to outer brackets. Turned off radio. Unconnected the speakers. Moved to outer brackets. Reconnect wires and no sound. Blue light is on the amp. Other speakers in boat work fine. I do not pull or reroute the speaker cables. Ideas?

Board no longer available. Any suggestions?

Enzo 211 Have pro ballast Was thinking of linking ballast bags to have factory pumps fill and empty two bags. Keep the midship bag connected with the fill and vents in place. Attach the drain of thr midship bag to the front drain of the Fly high dual drain port bag which sits in the rear locker. Attach the current aerator drain pump to the back of the fly high bag in the rear locker. Vent the rear locker bag and tie into vent line. Ideas?

Thanks for the info. I will try using just 750 bags in the rear locker and see if an improvement over 250 in the midship. Trying to make a nice wave on the cheap.

Would I be better off removing the midship bags(only 250 lbs a side) and placing 750 lbs in the rear lockers? I would use the plumbing for just the rear locker bag only.

Actually the wires powered the speakers at the inner mounting site prior to being moved. They were factory installed there . I did unscrew the speaker input piece to see if I would be able to just pull the wires to the inner bracket hole. Is there an alignment guide for the speaker input piece?

What are your settings for surf wake on enzo 211? I just have the pro ballast.

What do you run at? Do you run just one side? Or also a percentage of midship ballast? Thanks

Yes for surfing,