xsummit

I am really hoping new boat has the same wave with no bags. My current wave is nothing less than spectacular

Fyi my current set up is: Port 2012 enzo 233 Rear port locker 750 lb sac Mid port full 400 lb sac on seat 2 75 lb fat bricks on front port Port qfs full Trim at 50 Speed 10.3 People in boat 4 adults Stbd All same but 400 in rear locker Trim 100 Speed 10.3 All same

Thank you

Hi guys. Don't visit here much. How are you installing lead in your boats? Where do I get it? Do I put it in a container? Do I make it so it comes out of the boat easily? Do any of you have trouble down the road with your trailers cuz the boats heavier in spots now? Any info would be greatly appreciated. Thanks in advance

Hmm my 14 233 is on order and I was hoping to not have to deal with any other ballast. Doesn't sound like its going to go that way. Now I will need lead. How are you guys doing your lead in your boats? Thanks

Thank you. Mine is on order now and I can't wait. Would love to see your wave with little to no people and no rider. Jmho

Yeah, it would help if the heads were perfect too.

Is there a better or udated product for this gasket leaking problem?

What would you estimate the area to be? And thanks for posting

The distance from bottom of hull to prop blades is crucial. If less than 3/4" the chance of gel burn and creating a hole in your hull increases. Apparently some of the new boats have a dish above the prop blades to alleviate this problem. Any of you have this on your new ceturions? If so, could you please post a pic?

I am thinking about making a "dish" in the bottom of my hull to be able to swing a 14.5x22 acme prop as i have a new 13.5x19 with .165 thou cup and still hit the rev limmiter with my 8.1ho. My question is this: What are the affects of different props and their wash to the wave we are trying to create. I dont want to hinder my goofy wave worse than it already is.

What is a new triducer and where do you put that?

Theres alot more to it than just moving a bunk. It would be easier to move said ports in hull

I dont think he has the vibe in the steering wheel so much as the whole boat under hard accel. I could be wrong. On another note...I am very dissapointed in a few thing with my boat and trailer combo as well. The paddle wheel is so close to the bunk of the trailer that it is impossible not to wreck it if you have to load in the wind or even wavey conditions. The water intake for ballast on the bottom of the hull is so close to the trailer bunk it tears the carpet on the bunks. I know these are not issues with the centurion boats but somewhere along the line centurion had some input to which trailer their boats sat on and where support was needed. Are the new boats different and have thet relocated these items on the bottom of the hull?

Yep absoluteley correct. AWS guys says if there was not grease in there when i pumped grease in....then there is bigger problems down the line somewhere. So i booked it in for him to have a look. One of the only guys i talked with that understands motor alignment.