Ernesto

I just plumbed in my new 750lb sacs. Stupidly easy, just pulled out the factory hard tanks and put in the new bags. Same fittings, same place. NOW,,,, as the bags are filling up they only get about half way full before they start pouring water out of the overflow on the side of the boat. What does everyone do about this problem?

The fuse for the hatch was blow. But i had no clue what it went to. I replaced it and it still didn't work. I'll try taking the wires off the pump and plugging it directly to 12v. As for the diodes, Thanks for the info!!!!! I didn't know what they did. I'll be able to figure it out now.

I just got an 06 Avalanche C4. I can hear the 3 seperate motors running when i hit the switches to empty all the ballasts. I see that there is only one motor to fill all 3 ballasts. Not 100% how that works at the moment but i cant get it to run when i flip any of the switches to the fill position. Looking behind the switches i see that there are 3 little wires (maby electrodes, or resistors, not sure) that connect all of the power wires coming out from the switches. They all go into 1 white wire. BUT, my white wire is cut off about 2 inches after that and i have no clue if it is supposed to go somewhere. A wiring diagram is all i would need to fix the problem but i don't know how to get one. Anyone else ever have this problem? I can post a picture if you guys want.