Jump to content

Search the Community

Showing results for tags 'provision'.

More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


  • Feedback, Announcements and Crew Deals
    • Site Announcements
    • Site Feedback & Support
    • Crew Deals
  • CenturionCrew.Com
    • Centurion Boats General Discussion
    • Centurion Boat Accessories, Electronics and Modifications
    • Centurion Boat Maintenance, Performance, Troubleshooting
    • News From Centurion Boats and Dealers!
    • Centurion Boat Owners Hook-Up
  • SupremeCrew.Com
    • Supreme Boats General Discussion
    • Supreme Boat Accessories, Electronics and Modifications
    • Supreme Boat Maintenance, Performance, Troubleshooting
    • News From Supreme Boats and Dealers!
  • General Discussions
    • Watersports & Related Gear
    • Marine Audio
    • Articles by Members
    • Off Topic
    • Boat Shows, Local Events and Gatherings

Marker Groups

  • Members
  • Centurion Boat Dealers
  • Centurion Boats/Fineline Industries


There are no results to display.


  • Boats
  • Gear

Found 4 results

  1. New to the forum and Centurion ownership. I bought my first Surf boat after selling my 20 foot runabout. I purchased a 2010 Enzo 240 with the Pro Vision dash. The Baot came with the Switchblade wake system, but the Lenco rams are bad, but I know that it will work with new rams. I am selling the Switchblade system and moving to a tab system. My first modification to the boat is the addition to a center A-Plate trim tab as my wife is a goofy surfer and I want it to display on the Trim indicator on the dash. Does anyone know what it will take to tie the new trim tab into the Pro Vision dash? Has anyone done this? Also, can the actuator be controlled by the dash rather than using a Lenco switch?
  2. Hey everyone. I’ve tried to search on here and can’t seem to find an answer. How do you dim the display on a provision screen? Can’t find it under any of the settings. Is there a nob somewhere? It’s blinding at night. Recently new to me 2010 sv230 with provision 1 display I believe . Thanks for any help
  3. I need some help with my Pro-Vision screen. I tried to start my boat up yesterday, but instead of immediately turning over, the engine was silent and I heard a loud beep from the boat. I turned the battery by-pass switch on and then back off, and then it started up, but my Pro-Vision wouldn’t come into focus – it was just a blue screen. I spent a while tinkering around and reading the Crew help forums, taking the Provision unit out of the dash and ensuring all of the connections were seated properly. But still no luck beyond the blue screen. I could start up the boat, drive it, but I couldn’t see the speedometer, speed control, etc. Just a blue screen. I turned the battery by-pass switch on and then off quickly, and all of a sudden the ProVision came back on – and I was able to operate the boat with the Provision screen and all of the controls! So I drove around a bit, and then turned the engine off and back on and the ProVision was still working. But then a little bit later I tried to start the boat again and the provision was blue-screening. I played with the battery by-pass switch and it came back on. Any idea what’s going on? I have a 2010 Enzo 240SV with two batteries. Thanks. Don
  4. I just bought an Enzo sv244. I am trying to get my hands on an owners manuals that explains how the ballast system works. Also looking for an owners manual for the pro vison II system. Any help on this would be appreciated!

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy..