I need some help with my Pro-Vision screen. I tried to start my boat up yesterday, but instead of immediately turning over, the engine was silent and I heard a loud beep from the boat. I turned the battery by-pass switch on and then back off, and then it started up, but my Pro-Vision wouldn’t come into focus – it was just a blue screen.
I spent a while tinkering around and reading the Crew help forums, taking the Provision unit out of the dash and ensuring all of the connections were seated properly. But still no luck beyond the blue screen. I could start up the boat, drive it, but I couldn’t see the speedometer, speed control, etc. Just a blue screen.
I turned the battery by-pass switch on and then off quickly, and all of a sudden the ProVision came back on – and I was able to operate the boat with the Provision screen and all of the controls! So I drove around a bit, and then turned the engine off and back on and the ProVision was still working. But then a little bit later I tried to start the boat again and the provision was blue-screening. I played with the battery by-pass switch and it came back on.
Any idea what’s going on?
I have a 2010 Enzo 240SV with two batteries.
Thanks.
Don