Search the Community
Showing results for tags 'Help'.
Found 10 results
-
Does anybody know where the coolant line is on a 2004 Centurion Enzo SV230? I am winterizing the boat and didn't know if this was the best way to funnel antifreeze into the engine block. Thanks!
-
Guys, I am in the process of removing the 2 Factory hard tanks out to replace with sacs. They are each a 22 gallon tank. I got the port side out no issue, but I’m stuck with the starboard side. Any help would be appreciated. It’s an 04 Enzo sv230. Thanks!
-
Guys, I am in the process of removing the 2 Factory hard tanks out to replace with sacs. They are each a 22 gallon tank. I got the port side out no issue, but I’m stuck with the starboard side. Any help would be appreciated. It’s an 04 Enzo sv230. Thanks!
-
Guys, I am in the process of removing the 2 Factory hard tanks out to replace with sacs. They are each a 22 gallon tank. I got the port side out no issue, but I’m stuck with the starboard side. Any help would be appreciated. It’s an 04 Enzo sv230. Thanks!
-
04 Centurion Avalanche
mgcondra88 posted a topic in Centurion Boat Maintenance, Performance, Troubleshooting
Hello, if someone can help shed some like about this, I have been looking for a replacement hydraulic and haven't had any luck. I can't tell what the part number is, but one of my hydraulics are leaking on the Wake plate above the prop. There are two hydraulics on their. The gauge still says it moves up and down, but I can tell it is leaking. Thank you! I can post a picture later if needed! -
04 Centurion Avalanche
mgcondra88 posted a topic in Centurion Boat Maintenance, Performance, Troubleshooting
Hello, if someone can help shed some like about this, I have been looking for a replacement hydraulic and haven't had any luck. I can't tell what the part number is, but one of my hydraulics are leaking on the Wake plate above the prop. There are two hydraulics on their. The gauge still says it moves up and down, but I can tell it is leaking. Thank you! I can post a picture later if needed! -
04 Centurion Avalanche
mgcondra88 posted a topic in Centurion Boat Maintenance, Performance, Troubleshooting
Hello, if someone can help shed some like about this, I have been looking for a replacement hydraulic and haven't had any luck. I can't tell what the part number is, but one of my hydraulics are leaking on the Wake plate above the prop. There are two hydraulics on their. The gauge still says it moves up and down, but I can tell it is leaking. Thank you! I can post a picture later if needed! -
Pulled my prop shaft for bushing replacement in the strut. Can't tell if strut is bent or if it's an offset strut, can ANYBODY help me figure this out or help me with where to look to find out? Thanks - C -
Boat Purchase Advice - 2009 Enzo SV 240
pdhj1990 posted a topic in Centurion Boats General Discussion
I'm considering purchasing an 09 Enzo SV 240. Partial boat specs include: Perfect Pass Side Swipe Exhaust Cruise Gladiator Tower - Bimini - Tower Speakers Upgraded MB Stereo Duel Batteries Fuel Injection Wake Board Racks Depth Sounder Mercruiser 5.7 Mag 330 Hp Water Ballast System + Enzo sacs NADA Price $65,795 274 Hours Tandem Trailer The boat can be purchased between $50,00 and $52,000. The boat pics looks very good. I'll inspect the boat on Friday. My questions include: Is the price fair, assuming above average condition? Will the boat make a quality surf wake? Any issues with this year and model? Any items that require particular attention with this year and model? Should I consider a newer boat - 2013 SZ 230 or 2014 SV 244 - however these are $63,000 and $82,000 respectively? Thanks in advance for any advice? Paul -
I need some tips and advice on how to wieght my boat and wakesurfing. I have a 07 Centurion Avy C4 with stock ballast and trim tab.The ballast center tank holds 225 pounds , and the two rear tanks that hold 209 each. I have a Ronix Cortez wakesurfer i have all three fins in. I fill the center tank and the port side tank and set the trim tab on about 75% I have perfect pass set on 10.7 I mostly wakeboard but i have started surfing a little bit and really enjoy it. My problem is i am having a hard time staying in the wave. I have tried watching youtube videos, but still am having a hard time. I know the board is probably not the best but i think that i should be able to ride without using the rope. Do i need more wieght? Should i add it in the bow? Port side? Along the back seat? Does the Trim tab need to be adjusted? The wave doesnt seem long enough, and it doesnt feel like it is giving me enough push. Also when i do start riding without the rope i sometimes find myself like right up on the back of the boat, this is why i think my wave is not long enough. I try to put the brakes on, but then i usually find myself falling out of the wave. Any advice on what i am doing wrong would be appreciated. I also would like to hear what everyone thinks about the ballast set up. One more thing. I do not have enough guts to cut a hole in the hull of my boat so i was thinking about going with the Tsunami pump for any additional bags. Thanks
