Jump to content

TimF16

Crew
  • Content count

    22
  • Joined

  • Last visited

Everything posted by TimF16

  1. I have a 2009 SV 240 with the ZR 409 in it. It has the basic analog instruments but came from the factory with Zero Off on the speed control and the basic Faria Depth, Water and Air Temp gouge. The depth started to go bad and flash erroneous numbers. I thought it was probably the transducer so I got one that was exactly the same (Airmar DST 800 which is for speed, depth and temp). The problem is that it was wired at the factory and I am having a bit of a tough time figuring out how they did that and possibly run wires that may be the issue (or not). If anyone has any thoughts or experience with this set up I would appreciate any thoughts or opinions.
  2. I have the original Ampitheater 2 sound system with 3 Kicker amps, Sub, 4 tower and 8 in boat skylon speakers. The master switch will come on (light on in the switch) but I cannot power up the control heads. I have checked all of the fuses that I can find (back of control head and fuses along wiring) and have come up with nothing. Both of the control heads are MB Quartz. Any expertise would be appreciated.
  3. Hey, thanks for the suggestions and just for an update. The multi-meter told the tale....the ground wire on the bundle at the back of the control head (that I could not see) had worked loose and caused the problem. A little solder and it was good to go. Thanks again Centurion Crew
  4. That was my next course of action. I ran out of time today to get the voltmeter out and crawl under there. Thanks for the response. Do you have an MB Quartz head?
  5. I have a 2009 SV 240 with the 409 and have found the Enzo sacks work really great. Fully agree to get rid of the sprinkler valves and manifold. I wake board and surf. To be honest...most of the really good boarders who ride behind my boat can't believe how nice the wake is without any ballast in at all. I put a little ballast in one side or the other to even out the wakes and that's it.
  6. Tower Speaker Issues

    I have the 2009 Ampatheater II soundsystem in my Enzo 240 and all of the tower speakers just quit a few days ago. I am good with mechanical but am fairly lost in the boat stereo world. I've run down all of the things that I could think of. The boat has 3 Kicker amps and the tower speakers are the big rubicons, head is an mb quartz Any help with troubleshooting would be greatly appreciated
  7. Tower Speaker Issues

    I have the rca cables hooked up per the diagram but I have not tried pushing the fader switch in yet but I will give that a try
  8. Tower Speaker Issues

    the fade button is out. what is the chance that the amp has one side bad? Thanks for the help
  9. Tower Speaker Issues

    Hey, I just got the new amp in the mail and wired it up. I thought that I was getting the original kicker 350.4 but it is the ZMX350.4. The wiring is a bit different but I do think that I've wired it correctly. I have changed it around a few times and it seems that I can only get output from one of the 2 amps. (4 tower speakers and I can only get one of them to work). Any ideas on this one?
  10. Tower Speaker Issues

    Hey Man, I attached a working speaker to the amp and got no results (I also tried it with the ipod attached) so I am guessing that my issue is with the amp. Did put a voltmeter on the power cable and got good voltage there.
  11. Tower Speaker Issues

    I am pretty sure that they are, but the wiring was done at the boat build time and they are hidden. I've run out of time today so I will get back on it this weekend. I really appraciate your help
  12. Tower Speaker Issues

    The Amps are (3) Kicker 350.4's. The Rubicons are (4) 175's
  13. Tower Speaker Issues

    Hey Guys, I did check the problem out with the ipod and got no sound out of the amp. I did the same thing to the other amp's to make sure that I was doing it correctly and got good sound out of them. the setup under there looks like the one amp powers only the sub and one seems to power the 6 speakers down in the boat (those are the 2 that work with the ipod test as well). Is it a normal setup to have all of the tower speakers (4) on one amp? If so what would you check first in this scenario
  14. Tower Speaker Issues

    Thanks for the ideas guys, I am getting on it now. The amps have the small green light that was mentioned above and all are on.
  15. Tower Speaker Issues

    I mainly checked the wiring from the head to the amps and checked for anything that I could find up under the panel that might be loose. Also checked that the amps were powered and the fuses not blown.
  16. XM/Sirrus

    Just wondering if anyone out there would know if or how to find out if a system is Sat ready. I have a 2009 Enzo 240 with the factory Ampitheater II sound system. All Kicker and Skylon stuff. Thanks
  17. I had a similar problem with my Enzo 240 which has the PCM-409 engine in it. If it is a pcm engine this problem is unique to it. The high pressure filter which is located within the fuel control cel can be clogged fairly easily (very small micron) any amount of contamination at all will choke it. Mine was doing the same thing. Run for a while sounding normal and then just seem to lose power. Centurion dealers were not much help because it was a fairly new motor type. A PCM mechanic told me to change both the in-line filter and the high pressure filter and that worked immediately. Seems that ethanol will not make it through the high pressure filter if it has been in the tank for very long. Mine is a 2009 but I think that the newer boats have a spin on oil filter type in line fuel filter but mine has the standard one that looks like a small metal canister in the fuel line from the tank to the pump.
  18. MY 2009 Enzo 240 has the PCM 409 with the power plus transmission and v drive. It is advertised to be maint. free. this summer while surfing I have had the red v drive light on the dash come on a time or two. It's only happened when out for a few hours pulling slow. When I turn the motor off and then back on the light goes out and stays out. Nothing seems especially hot back there even though it's over 100 degrees out. Checked fluid etc. and all is fine. Anyone have any thoughts on this. I'm thinking that I might have a sensor going bad in there.
  19. I had a sudden spike in engine temp today and am starting at the raw water pump impeller. Does anyone have experience and advice with the PCM engines wrt replacement.
  20. Hey, thanks for the response. The boat is a 2009 Enzo 240. I have not heard anything about overheating bulletins but I will check it out.
  21. A friend has a 2006 Avalanche with a bad alternator. Dealer told hime it would be over 400 to replace. I told him that I would change it for him. Anyone have any experience with this model. I've changed them on older Malibus and Mastercraft boats. I currently have an Enzo 240. I know I can get it cheaper and change it easily but I was wondering if there might be some tips. thanks
  22. Hey I am the new owner of a Centurion Enzo 240 (made the transition from a Wakesetter 23 LSV). The boat has the new PCM ZR-6 409 engine with contained cooling. The boat will soon be in a boathouse with a heater and i am in North Carolina where it does not freeze much. Ive basically just removed the hoses from the raw water pump and not much else. Is there something that I should be aware about beyond this. By the way, I love this boat
×

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy..