hummer2482
Crew-
Content count
14 -
Joined
-
Last visited
-
06 Avalanche upgrade ballast bags
hummer2482 replied to hummer2482's topic in Centurion Boat Accessories, Electronics and Modifications
Ok that might work but i wanted to know if the fly high will work with the factory plumbing. The one on wakemakers.com are on backorder and dont really wanted to wait -
06 Avalanche upgrade ballast bags
hummer2482 posted a topic in Centurion Boat Accessories, Electronics and Modifications
Anyone know of a fat sac other than wakemakers that will work with the factory lines in the 06 Avy? with the Fly High sacs work? what is needed for those? looking to do 750 on each side and get ride of the hard tanks. Thanks -
Factory Bimini Tops for sale?
hummer2482 posted a topic in Centurion Boat Accessories, Electronics and Modifications
Looking for a factory top for an 2006 avalanche with the evolution tower? Any Idea where you can get one. Don't really like the aftermarket ones. Thanks. -
Impeller change in 2007 Enzo
hummer2482 replied to hummer2482's topic in Centurion Boat Maintenance, Performance, Troubleshooting
Thanks! -
Impeller change in 2007 Enzo
hummer2482 posted a topic in Centurion Boat Maintenance, Performance, Troubleshooting
Does anyone know the part number for the impeller for the black merc scorpion engine and is it really that had to do yourself and the location. Thanks for your help. -
ballast seal question or part number help.
hummer2482 posted a topic in Centurion Boat Maintenance, Performance, Troubleshooting
need to know what this is called or the part number the seal inside is not letting in water to pass through to my ballast tanks removed the one on the other side and works fine. Think its a bad seal -
07 enzo with v-drive light question
hummer2482 replied to hummer2482's topic in Centurion Boat Maintenance, Performance, Troubleshooting
It was a check engine light and it was a bad knock sensor or someone before me put crappy gas in it -
07 enzo with v-drive light question
hummer2482 replied to hummer2482's topic in Centurion Boat Maintenance, Performance, Troubleshooting
it states around light like my past boats do...do not run v-drive if light is on over 1200 rpm and there is no audible buzzer or anything like that when you first turn key before cracking the engine up -
07 enzo with v-drive light question
hummer2482 replied to hummer2482's topic in Centurion Boat Maintenance, Performance, Troubleshooting
Ither info on this is that my light comes on when i turn key to ACC and when its running in neutral that is off...my older boat stayed on until i got to speed. Thanks for the help -
07 enzo with v-drive light question
hummer2482 replied to hummer2482's topic in Centurion Boat Maintenance, Performance, Troubleshooting
Pcm -
07 enzo with v-drive light question
hummer2482 replied to hummer2482's topic in Centurion Boat Maintenance, Performance, Troubleshooting
Can someone show me where if any sensors are or the baro sensors? -
07 enzo with v-drive light question
hummer2482 replied to hummer2482's topic in Centurion Boat Maintenance, Performance, Troubleshooting
What type fluid should you use in vdrive? -
07 enzo with v-drive light question
hummer2482 replied to hummer2482's topic in Centurion Boat Maintenance, Performance, Troubleshooting
Fluid is where it should, just changed it and the temp is under 175 more like 160-165 -
07 enzo with v-drive light question
hummer2482 posted a topic in Centurion Boat Maintenance, Performance, Troubleshooting
Have a light coming on only around 3340-3380 rpms as soon as I get off the throttle just a little, the light goes out. While in neutral, light is not on. Last boat I had, light stayed on until I got a little above 1300rpm....What could this be? I have changed all fluids with less than 1 hour of running time. No loss of power before during or after light...PCM with pleasure craft and Power plus with 1.00 ratio. Thanks for any and all help in advance.