wishbone1961

I am looking to gain a little fuel by changing my prop. I have searched endlessly for information but it is all over the place. Looking for any RI217 owners that may have swapped out to the Acme 1941 prop (14.5x15.5). Current prop is a 14.5x14.25. Dealer recommended the 1941. Any comments would be great! Thanks

Still having trouble with my ballast filling (starboard side). Strange issue. Its intermittent as well...which is driving me nuts. 2007 Enzo SV216. Has the four sprinkler valves. Clean filter. Pump is running. Impeller looks mint. I pulled the filter and turned the pump on and water came out. The strange thing is that the last two times it did this, once i removed the hose from the output side of the pump, it started working again. At least until I got it full. The very next time though it did the same thing. Is it possible that there is air pressure keeping the pump from priming after I had stopped filling? My service tech told me before I should get rid of the sprinkler system too. Thoughts?

Oh sorry, I thought that they both were based on the same main section. Just extra supports. Looked very close. I would still think Centurion may be able to assist. Thanks!

My dealer in NC had one ordered directly from Centurion. I have a 2007 Enzo with the gladiator tower. It also has the extra supports though unlike yours. Still you might be able to do that.

Anyone installed InfinityWave tabs on an Enzo SV216? I have a 2007. Using the suckgate, 750 in each back locker, the mid hard tanks but I still need to put a 400 bag on the surfside corner AND I have 400 lb (200 water, 200 steel) in the bow. Thats with usually about 2-3 people in the boat. REally interested in those tabs versus a whole new boat... figured i would start a separate thread in case my earlier post got lost in the shuffle....

Anyone installed InfinityWave tabs on an Enzo SV216? I have a 2007. Using the suckgate, 750 in each back locker, the mid hard tanks but I still need to put a 400 bag on the surfside corner AND I have 400 lb (200 water, 200 steel) in the bow. Thats with usually about 2-3 people in the boat. REally interested in those tabs versus a whole new boat...

Did you ever complete this project?

I did the interior of my 2007 Enzo 216 this year. The carpet was stained and after seeing some newer boats with seadek, I made the plunge. Did the templates and everything myself...Very easy. A little stressful in a few spots but it came out great! NOW...I want to do the center motor cover. Anyone ever pull that upholstery off? suggestions?