gravity12

So i figured since i will have my boat at my dock this season i would make a fae. 3 inch abs. 3 to 4 reducers into the factory exhaust. Braced to the trim tab. And siloconed and rivited to the boat exhaust. 40 bucks at the most and maybe 45 min to build. Let me know what you think. Cant wait to try it out soon.

Finally ordered up cruise. Hydrophase ridesteady gps. Cant wait to get it next week and install it. Its the one thing i have really been wanting to get for my elite v. I will post pics and review it.

I would call it more of bumper or spacer.

I'm interested in how the angle changes the wave.

What does your shaper look like

I think anything that builds confidence and is not a tube is great. Been thinking about getting one also.

I just capped them off.

What dealer are you getting Centurion through? I'm in spokane also.

Wakejunky. You are in cda correct? Have seen the new Centurions due to no dealers around but was not impressed at all with axis i have seen and the malibus have really lost the high end fit and finish i remember. I love my 2006 centurion amd if i could i would not hesitate to buy one of the new ones.

Its not easy unless you are a paying member. What did you want to share? Check out the official centurion and Supreme page on facebook. Much easier amd tons of active people.

Check out the official centurion and Supreme page on facebook. You can search the page. Several plates on there. This page is hard to add photos and most all traffic that was here is on the facebook page now.

Elite v doesnt have a step at the cooler.

Sundance in spokane does good work.

Any spy photos of the supreme thats coming out?

Where in the exhaust chain is this installed?

Bad tush. You need to put this on wake garage.

I have a 06 elite v. Getting it dialed. Plumbed rear bags and did hydrophase ridesteady. Run about 900 steal and lead. Home made suck gate. This site wont let me post pics. Check out chris butler on facebook or chrisbutlergcp on Instagram. Aren't you in the northwest?

And it fills much faster bypassing the sprinkler valve. One of the first things i did to my elite.

How much bow weight?

Hmmm. I need to see what mine does goofy. I almost wonder if sometimes more wieght works against us.

Only mix what you need in a seperate cup. Most auto paint supply stores have mold release. You can use plastic wrap. But it will make it rough and harder to wetsand.

I too thought that it was pre mixed and used it. Couldn't figure out why it would harden. Fineline has us all thinking its pre mixed but gel coat cure with out air so as soon as the put the lid on it would start to harded.

They send it with no hardener. You wll need harder to mix in it. I got some a few years ago and it will stay usable if the can is sealed. Tape about an inch around the repair with blue or green tape and then sand into the chip or scratch with 120 grit. Blend it out to the tape. You can use a brush to apply it. Then for it to fully cure you need to brush a mold release over it. Then let it sit over night. Then wash off the mold release and then wet sand the repair down smooth with the boat. Then buff it out. Lots of how to's online but thats the just of it. Not too bad on single colors but if you have a spot that two colors meet like i did its kind of a mean woman. Good luck.

I use a product called enzyme at the end of the season before i store it. Not sure if it helps but it cant hurt.

This is what i came up with. Hopefully it does the job and help the wake and wave. https://www.wakegarage.com/projects-archive/exhaust-modifications/fae-wakeplate-contraption-r123/