mike1219

Hello, I own a 2008 Enzo SV 220. Recently I have been having an issue with the boat slipping under a load (surfing) or accelerating hard. The engine compartment recently had quite a bit of water in it. We had a big rain storm and for some reason the bilge was not pumping out any water? From looking at posts on this site sounds like I may have water in the transmission oil and/or the Vdrive. Does my boat have a Vdrive and a transmission. The boat is 3 hours away and I need to pick up fluids in the city here. Can some body let me know what transmission oil I need and what fluid for the Vdrive? (Walter). Am I on the right track here. Is this actually my issue? Boat only has 120 hrs. Thanks for responses. Mike

Yeah i posted that topic as well but didnt really have any answers that explained how people have mounted them on evo towers in the past!

Hello Everyone, My Wetsounds Rev 8x's just arrived. Im looking to install them on my Evolution tower. I realized the tower has 2 bolt holes than a wire hole. The speakers came set up with a wire hole in between the 2 bolt holes. The guys at wetsounds said that these cans would bolt directly onto the lower mounting location on my Evo tower. I am just wondering how to get the speaker set up to mount them to my tower. There's the plate inside I'm not sure how to set up? If some one has installed these on an Evo tower and could share how they went about mounting them that would be awesome! Thanks, Mike

Yeah I may land up having to do that but if there is any other solutions I would of course prefer that

I have run into the problem where i can't get the plastic female plastic butt connector through the first hole. Do you have to cut wires to get it through? As well what do you do with the mounting bracket inside the speaker pod. Do you move it forward so the back hole the bolt doesnt even hit the bracket and the middle one the bolt just goes through the big hole on the bracket? And then do you have to drill a new hole in the bracket to get the wires through? Thanks, Mike

Hello, My Rev 8x's just arrive yesterday! I just started to take them apart and getting the mounting brackets set up right. I need to change the wire to run through the front hole instead of the middle hole like it comes. Because on the evo tower the first hole is for wire than the next two are mounting holes. I know people have mounted using the middle and last hole and routed the wire through the first hole i am just wondering how to do this? I cant seem to find a way how? Thanks Mike

Thinking about buying a pair of either pro60x's or a pair of icon 8's. I was wondering which speaker would give me better performance. Generally we do a lot of surfing with a little bit of wake boarding. From my understanding the pro60x is an HLCD and the Icon 8 is just a coaxial. So I'm assuming the pro60x could be heard from farther away. Let me know what you guys think is better. Thanks, Mike

yes, boat is just in shop but should have it back early next week ill take a pic than

Do you know of any solution to the different mounting hole spaces. Like the tops are probably a half inch narrower than the bottom holes.

And no both of there locations are in BC and i live in manitoba

I live here!

Another question Wake doc might know the answer to this. If i decided to put pro 80s on the tower right now than in a year or two decide to throw a pair of rev 8's on will all that speaker fit. I know they might overlap a bit but just wondering if they will fit on the factory mounting locations without hitting each other

You can buy a new set of Pro 80's from wet sounds directly for $700 haha

My mounting holes on my evo tower differ between the top and lower mounting locations. After researching i came across the conclusion that the lower mounts will accommodate any x version speaker while the upper mounts you need to buy bracket (which wet sounds USED to make) to mount a regular version of the can onto.

Would also consider a pair of Icon 8's if any one has