superdtf

...and you're going too fast.

...don't counter-sink it from the other side... you might need to get more weight forward (you don't wanna be poppin a wheelie down the lake), but keep it all on one side, until you are pushing +2k pounds. Good rule of thumb is get one side of the swim platform 12" under the water, and the other end is 12" out. At this point you'll notice to only turn back to your rider on the "sunk" side. You shouldn't have to screw around with a "wake shaper" ... that might be icing once you got this cake baked.

That^^ Dude knows...

Did you swap your ballast? Enzo sacs? I love the Switchblade

Wakemakers makes an 1150. What'd you end up doing? That Avy can surf like a mofo with the ballast slammed down.

That ^^ Slam it down. Get the 1500 enzo sacs and enjoy your life.

How'd those rams work Pack? I've got an old Enzo (2007) I'm eyeing to restore (remove the tower, rehab the switchblade, put a bitchen bimini on it, carpet/upholstery) and surf our brains out.

Don't worry about the "shapers" until you slam it down with ballast. It's a bit daunting the first couple times, but you'll get used to having the rub rail right on the water. Even the new boats (new Tige) we slam it down...

And when you're done, put enzo sacs in there...

Oh man....

My buddy has a newer (2016 I think) Wakesetter. He still prefers it when I show up, slam up one side, move the people in a bossy voice, and take the "Malibu wake stuff" mostly out of play. Just up/down trim, and tiny bit of surfgate.

You should try really hard to rehab them. Lube, soft-metal mallet, patience.

I love these old boats. My classic boat is a Ski Nautique (1980), but God, I love these old boats.

The light simply indicates that the switch is sending electrons down the wires; it doesn't tell you that your pump is bad (that's what the lack of pumping sounds tells you :-) ). Try and find the same pump so that R&R is easy.... you get a different form factor pump, and then you have to do work.

Nice. Can't believe you waited that long.

I never lube mine. I think it's designed to work with water.

Excellent. Nice work Pecanflyboy!

We still slay with an '08 - '10Enzo and enzo sacs from wakemakers and a switchblade. The newer boats are a bit better, and easier, but you would have to get into 2013 models to do it.

Maybe try more...

This is so awesome. This thread started like 7 years ago...

Don't look, just surf. :-)

That's about right, a little over $300 (in 2011). They bolted right up to the boat, and there was a bit to work out with the holes on the deck; no big deal, use some 5200 of an appropriate color.

Don't put a check valve in. It's not setup for the pressure/flow. Absolutely put a valve in if you don't have one. It'll save your boat when the pooh goes down.

Yup, replaced my '08 brackets in '11. Call your dealer, or Shelly at Fineline, they'll be expensive, stainless, and perfect. You might have to sort out the holes in the deck, but you'll figure it out.

Your surfing will be more fun if you don't look... ;-)