2001 eclipse

I have a 2001 eclipse and it does great but it is a v drive. I am also in my 40s and wakesurf behind my boat it just has to be waited properly.

One thing that will help this from happening again is take some oil and put on your finger and rub it on the gasket prior to the install. This will keep it from ceasing up like that .

Yes the last two # are the length it looks like a 20 to me also

With this much rust I would do a serous assessment of the trailer and see how far the rust has gone if has gotten To the axle or the spindles this could be very dangerous to tow.

Your center ballast tank is about 250lbs

Ok thanks that what I though

Does anybody now of hand if there is way to find out what size bearing I have on my trailer with out me taking it apart first. I have a trail rite trailer. Just wondering if there a Standard size or not. Thanks in Advance.

Does anybody no if there a way to find out what size bearing I have on my trailer without removing them first. I have a trail rite trailer.

Also check cap and rotor

I was checking my shaft seal after adjusting it and put my hand on the bottom of trans. And notice it was hot to the touch is this normal. Thanks in Advance

Ok thanks

Had a question about this I went to work on it and put the wrench on the large nut and it was finger tight. Should I be concerned.

You have to add the snaps your self but they give them to you and it's not that hard. It comes with a tool to do it and every thing.

You can order the snap in carpet from fineline. I payed $300 dollars for mine size to fit.

It is really hard to get all the oil out so you have to figure for left over