Viking's S226

[h20king 794]

Stereo Progress - Got the RGB rings installed and the Reve10's wired up and mounted.

Used WS swivel mounts and I'm glad I went with only 1 pair because another set will not fit on the lower mounts on the S4 tower. Maybe if utilizing fixed mounts but it will be extremely close if it works??

http://www.centurioncrew.com/public/style_images/master/attachicon.gif Rev10 Swivel Clamp.jpghttp://www.centurioncrew.com/public/style_images/master/attachicon.gif Rev10 mounted.jpghttp://www.centurioncrew.com/public/style_images/master/attachicon.gif Rev10 pair.jpg

 

ok how did you get the rgb wire in the tower?? Did you use the factory wire as a fish and pull new wires?? One mount is on the front tube and one is on the rear tube but both exit on the front tube on the passenger side. My assumption is the wire makes a hard turn inside the tower because I cant get my fish through. Edited April 16, 2016 by h20king

[viking 491]

Some human ingenuity...LOL

I used a piece of plastic tied to fishing line and then used vacuum to suck it through. Couldn't figure any other way to make those tight bends.

I even took a picture in case somebody asked.

[h20king 794]

Was your tower pre wired??

[h20king 794]

Never mind I see in the pic it was.

[stoked 1,039]

Some human ingenuity...LOL

I used a piece of plastic tied to fishing line and then used vacuum to suck it through. Couldn't figure any other way to make those tight bends.

I even took a picture in case somebody asked.

 

IMPRESSIVE!!!!

[DarksideR 1,679]

Mind...

Blown!

[stoked 1,039]

Seriously, this is the smartest thing I've ever seen on here and maybe even the Internet. Well done!

[traysonh 11]

You all give him too much credit. I have a feeling that tip came from his previous boat life! Lol

[viking 491]

Finally got my sub enclosure facade done so thought I'd update my thread with that and other items marked off the list this winter:

What I started with and end result under helm:

 

I replaced the rear heater vent with a hot tube:

 

 

 

 

[viking 491]

Installed Natuic Logic GPS receiver. Was easy plug and play. Just had to contort myself to get to the connections under the floor located on top of the gas tank.

I positioned the receiver puck up on the dash. Really easy install.

 

I had Evolution Covers make a swim platform cover

 

I have a custom sack coming (Thanks NW Boat Sports) and after a few warranty items get knocked out this week I should be set for this season.

 

[viking 491]

And still have a few crew tattoos that need to find a home!

 

Edited April 26, 2016 by viking

[2ndtimearound 7]

Viking, I like it. The sub looks GREAT! I stuck the gps puck outside the window. It probably doesn't make a difference but on my last boat I had it inside the windshield and I noticed occasionally it took a little while longer grab the satellites.

Edited April 26, 2016 by 2ndtimearound

[h20king 794]

My sub install is almost done. Was able to squeeze in a ported box this time

[DarksideR 1,679]

Awesome work Viking!

And H!

[Nick213 583]

X2!!!!!

But H bigger boat need bigger speakers...........

You need a W7 13

[viking 491]

Thanks guys!

Nick that's funny stuff..........and agree!

I was pondering ported but wasn't 100% confident in my enclosure building skills last winter so opted for sealed. After all is said and done I think I could have handled it and would have likely built a full facade for front. But this way it allows me to keep some storage space and full use of the netted pocket. Enjoyed the use and tunes all last season but finally got around to making it look like it came from factory

[h20king 794]

X2!!!!!

But H bigger boat need bigger speakers...........

You need a W7 13

thought about it but decided to take tru's advise putting together a nice system while also keeping the cost down. It just doesn't make sense to spend that sort of cash on a system just to pass it to the next guy when we get a new boat in two years.

[Nick213 583]

Thanks guys!

Nick that's funny stuff..........and agree!

I was pondering ported but wasn't 100% confident in my enclosure building skills last winter so opted for sealed. After all is said and done I think I could have handled it and would have likely built a full facade for front. But this way it allows me to keep some storage space and full use of the netted pocket. Enjoyed the use and tunes all last season but finally got around to making it look like it came from factory

You did a amazing job Viking and it dose look like it came from a factory!

thought about it but decided to take tru's advise putting together a nice system while also keeping the cost down. It just doesn't make sense to spend that sort of cash on a system just to pass it to the next guy when we get a new boat in two years.

H great job with the shaping of the contours it gave it a clean custom look!

I'm aware, and would do the same. His advice has been spot on for my "needs" as well

Edited April 27, 2016 by Nick213

[DarksideR 1,679]

thought about it but decided to take tru's advise putting together a nice system while also keeping the cost down. It just doesn't make sense to spend that sort of cash on a system just to pass it to the next guy when we get a new boat in two years.

That doesn't sound like you at all! I'm kinda disapointed you cheaped out.

 

 

LOL. JK. totally makes sense.

[h20king 794]

That doesn't sound like you at all! I'm kinda disapointed you cheaped out.

 

 

LOL. JK. totally makes sense.

still did a nice system. Six ws 65i in boats on a ws ht 6 a set of Rev 10's on a arc 600.2 and a jl 12w3 on a ws htx2 ws 420sq plus rgb led's on a ws controler