Jump to content
Sign in to follow this  
marsh9man

Hesitation-Bogging from 1,000 to 2,000 RPM

Recommended Posts

marsh9man    0

Thanks in advance for any help!

2004 centurion elite 350 with 800 hours that I've had for 15 years.

Boat starts and idles fine, but bogs down when I accelerate until about 2,000 RPM's and then jumps up to acceleration. It will sometimes stall if I return to idle, but start again fine. I can hear a pump prime when I turn the key.

End of season last year it was idling erratically and a little high and stalling when returning to idle from acceleration with an occasional surge when cruising. Since then I have:

New cap and rotor

New fuel filters (both)

Drained old gas and replaced with new gas and sea foam.

New IA muffler and IAC valve.

 

Wondering if maybe it's a pump or sensor issue?

Any suggestions for further troubleshooting?

 

 

 

Share this post


Link to post
Share on other sites
marsh9man    0

Just wanted to follow up in case this helps someone else.

After also replacing plugs, wires and MAP sensor, I finally fixed the problem by replacing the Throttle Position Sensor.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

Sign in to follow this  

×

Important Information

By using this site, you agree to our Terms of Use and Privacy Policy..